4 © Titan Tool Inc. All rights reserved.
English
Maintenance
Use the following procedures to keep your HVLP spray system
running properly.
Cleaning / Replacing the Filters
IMPORTANT: Make sure the turbine is unplugged before
changing the filters.
1. Remove the lter covers on each side of the turbine by
turning them counterclockwise.
2. Remove each lter set from the lter cover on each side of
the turbine.
Filter
Filter cover
Screen
Silencer foam
Filter
Screen
Silencer foam
Filter cover
3. Clean the lters. Either tap the lters to knock out the
contaminants or use pressurized air to blow out the
contaminants. For material that is not blown or knocked
loose easily, soak the lters in soapy water or mineral
spirits. Allow the lters to dry completely before placing
them back in the turbine.
NOTE: Donotusehighlyammablesolvents,suchas
lacquerthinner,tocleanthelters.
4. Insert each lter back into its corresponding lter can.
5. Replace the lter covers on each side of the turbine by
turning them clockwise.
After several cleanings, it may become necessary to replace the
lters. Refer to the parts list near the end of this manual for the
lter replacement kit part number.
Cleaning the Air Hoses
1. Periodically wipe the outer surface of the air hose with a
damp cloth to keep clean.
IMPORTANT: DO NOT submerge into or flush the air hose
with water or any chemical.
IMPORTANT: DO NOT use methylethylketon (MEK),
naphtha, mineral spirits, paint thinner, xylol/xylene, or toluel/
toluene to clean the air hose. Exposure over time could
cause damage to the hose.
IMPORTANT: Store indoors with the cord wrapped around
the handle.
