© Titan Tool Inc. All rights reserved. 27
3. Remove the plastic plug from the main bar. Slide the
extension bar through the clamp upright and the main bar to
the desired position. Tighten the clamp knob to secure the
clamp upright and the extension bar.
4. Mount the gun holders as shown in the Cart Assembly
exploded view drawing in this section.
5. Locate the second gun outlet on the pump. Remove the
plug and screw in the second gun hose.
6. Insert the cable bushing into the guide plate. The first gun
cable and the second gun cable should be parallel.
7. Insert the hooked end of the cable into the lever plate.
Make sure it engages the plate.
8. Reconnect the trigger cables to the guns. Connect both
cables to the blocks.
NOTE: Once the second gun is in positio, the trigger
cables can be installed on both guns. Make sure
the trigger cable from the second gun is
disconnected before performing the next step.
NOTE: The main bar has a clearance hole for the clamp
knob to go through and tighten onthe extension
bar.
Main Bar
Clamp Upright
Extension
Bar
Clamp Knob
Remove plastic plug.
Tension Adjustment
To increase tension, loosen the screw in the cable tension clamp
block on the gun arm. Slide the block forward to increase the
gap between the lever and the point where the trigger touches
the gun arm.
To decrease tension, slide the block backwards. Make sure
there is about 1/32” to 1/16” gap between the trigger lever and
where the trigger touches the bar.
Before making any adjustments to the gun, always move the
gun’s trigger lock to its locked position and release the
trigger cable from the block by lifting the cable up and out
of the block. There will be a brief triggering of the gun when
you release the cable.
CAUTION
Check gap here
Cable Tension
Clamp Block
