Epic 1200HPG
Figure 2
Throttle
Hose Rack
Gas Tank
/Air
Fliter
Engine Muffler
Starter
Paint Filter
Figure 1
General
Repair
&
Service
Notes:
WARNING: Before proceeding, follow the Pressure
Relief Procedure outlined on Page 5. Additionally,
follow all other warnings to reduce the risk
of
an
injection injury, injury from moving parts or electric
shock.
The following
tools
are needed when repairing this
sprayer:
Phillips Screwdriver
Needle Nose Pliers
Adjustable
Wrench
Rubber Mallet
Flat-blade Screwdriver
1/2" Open End Wrench
3/8" Allen Wrench
5/16" Allen Wrench
1 /4" Allen Wrench
3/16" Allen Wrench
1 /8" Allen Wrench
! .
Befo~e
repairing any part of the sprayer, read the
mstruct1ons carefully, including all warnings.
2. When disconnecting wires, use needle nose pliers to
separate mating connectors.
Add Piston Seal
Lubricant here
Pail Hook
Choke
Fuel
Shut-off
Fluid Section
3
Figure 3
Frame
NOTE: A
Repacking
Kit
(762-175)
is
available.
All
parts
included
in
the
kits
are
listed
in
parts
list
chart
on
page
24.
For
best
results
use
all
parts
supplied
in
the
Repacking
Kit.
CAUTION: Never pull on a wire to disconnect it.
Pulling on a wire could loosen the connector from the
wire.
3. Test your repair before regular operation of the
sprayer to be sure that
the
problem is corrected. If the
sprayer does not operate properly, review the repair
procedure to determine if everything
was
done correctly.
Refer to the Troubleshooting Charts to help identify
other possible problems.
4. Make certain that the service area is
well ventilated in
case solvents are used during cleaning. Always
wear
protective eyewear while servicing. Additional protective
equip.ment
may
be required depending on the type of
cleamng solvent. Always contact the supplier of
solvents for recommendations.
5. If you have any further questions concerning
your
TITAN Airless Sprayer, call TITAN:
Customer Service Department 1-800-526-5362
Fax 1-800-528-4826
Outside the U.S. Call1-201-405-7520
Outside the U.S. Fax 1-201-405-7449
Canada 1-800-565-8665
Fax 1-905-856-8496
