A SERVICE OF

logo

Open as PDF
next previous
Computer Communications with the PV100S
152379 Rev C 2–27
Starting Setup From a Command Prompt
To start the program from a command prompt:
1. Insert the XANTREX SOLAR INVERTER GUI – INSTALLATION CD
into your CDROM drive.
2. Click on START and select “RUN”.
3. Enter the drive letter assigned to your CDROM and the name of the
installation program as shown in Figure 2-10.
4. Click O
K. The splash screen shown in Figure 2-11 will appear.
5. Proceed to the Model Specific Software Installation section on page 2–28 to
continue with the installation.
Figure 2-10
Starting Setup from a Command Prompt
Important:
The drive letter assigned to your CDROM may be different from the one
shown in Figure 2-10. Be sure to use the correct letter for your drive or the program will
not start.