Page 3 - 10 Xerox Document Centre System Administration Guide
Windows Internet Name Service (WINS) Installation
Before You Start
If your printer is equipped with a Token Ring interface, use the
100BaseT Ethernet or Token Ring Quick Install Card supplied
in this Quick Install Card set to configure the Ring Speed and
Source Routing settings for your environment.
Your Document Centre now has DHCP, LPR, and NetBIOS over
the IP protocol enabled by default. If your DHCP server will
provide the IP address, Gateway address, Subnet Mask for the
Document Centre, and WINS server address(es), the TCP/IP
information will be configured on initial boot. This means that if
you have configured your DHCP server with the desired
information, you may connect your Document Centre to your
network and it will boot and register with the WINS server
automatically.
NOTE
Your DHCP server must return at least one (1) WINS server
address to the Document Centre in order to enables WINS
registration.
In this mode the default NetBIOS host name, SMB host name and
the DNS host name for the device will be the letters XRX followed
by the MAC address of the network interface.
Example:
XRX08003E313E0A
If this NetBIOS host name is acceptable you can go right to the
section in the next section entitled Go to the Workstation and....
and complete those steps.
To change the NetBIOS host name for your printer follow Steps 1,
2, and 3 then skip to Step 5 and finish the Go to the Document
Centre... portion. When you finish that section, go to the section
entitled Go to the Workstation and.... and complete those steps.
