Almeda 230i Car Amplifier User Manual


  Open as PDF
of 36
 
Chapter 4: Using the remote control
Locating the remote control 16
Setting the projector for high altitudes 16
Replacing the remote control battery 17
Your SMARTTable includes a remote control for the projector. SMARTTechnologies configures the
projector for your SMARTTable and you need to use the remote control in the following situations
only:
l Setting the projector for high altitude use
l Resetting the projector lamp time after replacing the projector lamp
C AU TI ON
SMARTTechnologies recommends that you use the remote control to complete only the
procedures documented in this chapter. Using the remote control for other purposes may change
the projector’s settings, which were specifically configured for the SMARTTable.
N OTE
The projector’s receiver is located at the bottom of the projector. If you need to use the remote
control to make changes on the projector’s menu, open the door and point the remote at the bottom
of the projector.
Chapter 4
15
 previous next