Filter
Top Products
Important information
W A RN I NG
l Failure to follow the installation instructions shipped with your SMARTTable® interactive
learning center could result in personal injury and product damage.
l Ensure that any cables extending across the floor to your SMART product are properly
bundled and marked to prevent a trip hazard.
l Make sure an electrical socket is near your SMART product and remains easily accessible
during use.
l Lock the casters before allowing children to use your table.
l Do not climb (or allow children to climb) on your table. Climbing on your table could result in
personal injury and product damage.
l To reduce the risk of fire or electric shock, do not expose your SMART product to rain or
moisture.
l Do not stare (or allow children to stare) directly into the projector’s beam of light.
l Do not attempt to service the projector other than by performing routine lamp replacement.
Only an authorized service provider should provide service. Aside from the lamp module,
there are no user-serviceable parts inside the unit.
l Do not remove any screws other than those specified in the lamp replacement instructions.
l Do not touch or replace the projector lamp (which will be very hot) for at least an hour after
shutdown. Touching the lamp can cause severe burns.
l Do not puncture, crush, heat or disassemble the remote control battery, expose it to fire or
any liquid, short its terminals, or abuse the battery in any other way because this may cause
the battery to explode or ignite, and could cause a fire or personal injury.
l If the remote control battery leaks, ensure that you do not get battery fluid in your eye. If you
do, immediately rinse the affected eye with water and seek medical attention.
l Do not install the remote control battery backward or reverse its polarity. Do not install
battery types other than the one specified in the documentation. Both of these actions can
cause damage to the remote control and can cause a fire or personal injury.
i