Filter
Top Products
9-EN
Initial System Start-Up
Be sure to press the RESET button when using the unit for the first
time, after installing the CD changer, after changing the car battery, etc.
1
Turn off the unit power.
2
Open the door.
Refer to “Loading and Unloading Discs” on this page.
3
Press RESET with a ball-point pen or similar
pointed object.
Switching between NTSC and PAL
Set the output configuration to NTSC or PAL, depending on the disc.
Press and hold the PWR button for at least 2 seconds.
•PAL is the standard and there is no need to change the setting. The
system is set to PAL at time of shipment from the factory.
Loading and Unloading Discs
Turn on the power before loading and unloading discs. (Refer to
“Turning the power on and off” on page 8.)
Loading discs
1
Slide the door down to open.
2
Insert the disc with the label side facing upwards.
Once the disc is partially inserted, it is drawn in
automatically. Playback starts.
OPEN
3
Close the door.
Be sure to close the door to prevent dust from entering the
unit.
• If the ignition key is on ACC or ON, a disc can be inserted even
when the power is OFF.
•For two-sided DVDs, play one side of the disc to the end, then
unload the disc, turn it over and reload it to play the other side.
•Never insert map discs for navigation purposes as they could
damage the equipment.
• If wrong disc, upside-down discs or dirty discs have been inserted,
“DISC ERROR” is displayed. Open the door and remove the disc.
Unloading discs
1
Slide the door down to open.
2
Press c.
Be sure to remove the disc.
• If the disc is not removed within a few moments, it will be reloaded
automatically.
3
Close the door.
Be sure to close the door to prevent dust from entering the
unit.
•Never close the door while the disc is being unloaded. Doing so
could scratch the disc or damage the player.
• If the ignition key is set to ACC or ON, a disc can be removed even
when the power is OFF. After removing the disc, the power turns
OFF again automatically.
• During ACC OFF or while the disc is being loaded (“LOADING”
is displayed), the disc will not be ejected even if you press c.
OP
EN
OPEN
c
RESET