Filter
Top Products
14-EN
01GB04CDE121.fm
ALPINE CDE-121 68-16909Z79-A (EN)
Adjusting Subwoofer Level/
Bass Level/Treble Level/
Balance (Between Left and
Right)/Fader (Between Front
and Rear)/Defeat
1
Press Rotary encoder (AUDIO) repeatedly
to choose the desired mode.
Each press changes the mode as follows:
SUBWOOFER BASS LEVEL TRE LEVEL
BALANCE FADER DEFEAT VOLUME
SUBWOOFER
Subwoofer : +0 ~ +15
Bass level: –7 ~ +7
Treble level: –7 ~ +7
Balance : L15 ~ R15
Fader : R15 ~ F15
Defeat : ON/OFF
Volume : 0 ~ 35
• If no operation is performed for 5 seconds after selecting
the SUBWOOFER, BASS LEVEL, TRE LEVEL,
BALANCE, FADER or DEFEAT mode, the unit
automatically returns to normal mode.
2
Turn the Rotary encoder until the desired
sound is obtained in each mode.
By setting DEFEAT ON, previously adjusted settings of
BASS LEVEL and TRE LEVEL will return to the factory
defaults.
Setting the Bass Control
You can change the Bass Frequency emphasis to create your
own tonal preference.
1
Press SOUND repeatedly to select the BASS
mode.
BASS TREBLE BASS
2
-1 Press BAND to select the desired bass
center frequency.
80 Hz 100 Hz 120 Hz 60 Hz 80 Hz
Emphasizes the displayed bass frequency ranges.
2
-2 Press SOURCE/ to select the desired bass
bandwidth.
Changes the boosted bass bandwidth to wide or narrow.
A wider setting will boost a wide range of frequencies
above and below the center frequency. A narrower
setting will boost only frequencies near the center
frequency.
2
-3*
1
Turn the Rotary encoder to select the
desired bass level (–7~+7).
You can emphasize or weaken the bass level.
3
Press and hold /ESC for at least 2 seconds
to return to normal mode.
• If no operation is performed for 15 seconds, the unit will
return to normal mode automatically.
• The bass level settings will be individually memorized
for each source (FM, AM, CD, etc.) until the setting is
changed. The bass frequency and bass bandwidth
settings adjusted for one source are effective for all other
sources (FM, AM, CD, etc.).
• The function is inoperable when DEFEAT is set to ON.
*
1
The adjustment can also be made by pressing Rotary
encoder. Refer to “Adjusting Subwoofer Level/Bass
Level/Treble Level/Balance (Between Left and Right)/
Fader (Between Front and Rear)/Defeat” (page 14).
Sound Setting
BAND
SOUND
SOURCE/
/ESC
Rotary encoder (AUDIO/LOUD)
Setting the Bass Center Frequency
Setting the Bass Bandwidth
Setting the Bass Level
01GB00CDE121.book Page 14 Monday, December 13, 2010 2:03 PM