Filter
Top Products
8-EN
Basic Operation
MODE INTLZ/DISP SOURCE A.PROC
BLACK OUT TUNE DN g f UP
Setting the AUX Mode
You can input TV/video sound by connecting an
optional Ai-NET/RCA Interface cable (KCA-121B)
to this component.
1 Press and hold the INTLZ button for more than 2
seconds.
2 Press the f UP button repeatedly to select
"AUX" .
Each press of the f UP button changes the
modes as shown:
NOTE
If you press the DN g button the display scrolls in
reverse sequence.
∗
Displayed after AUX ON is set.
3 Press the TUNE button to toggle the mode
between AUX ON and AUX OFF.
NOTES
• The initial setting at the factory is AUX OFF.
• You can set the AUX mode display by pressing the DN
g or f UP button after AUX ON is set, select
the AUX mode display setting, and then press the
TUNE button.
4 Press the INTLZ button for at least 2 seconds to
activate the normal mode.
5 To adjust the volume, etc., first press the
SOURCE button and select the AUX mode, then
make the necessary adjustment.
→ TUNER → CD → AUX
NOTE
When AUX ON is selected, you cannot select the changer
to be used even for a connected changer.
Demonstration
This unit has the Demonstration feature which
simulates the display functions on the display panel.
1 Press and hold the INTLZ button for at least 2
seconds.
2 Press the f UP button to select the DEMO
mode. Each press changes the modes as shown:
NOTE
If you press the DN g button the display scrolls in
reverse sequence.
3 Press the TUNE button to turn on or off the
DEMO mode.
Each press toggles between DEMO ON and
DEMO OFF.
If no buttons are pressed 30 seconds after the
DEMO mode is turned ON, "DEMO" blinks 3
times in the display. The DEMO mode then
begins.
NOTE
The initial setting at the factory is "DEMO OFF".
4 Press and hold the INTLZ button for more than 2
seconds again to return to normal operation.
Adjusting the built -in Audio
Processor
You can change the Bass/Treble Frequency
emphasis, High Pass Filter, Low Pass Filter, and
Sub Woofer Phase on this unit, so that you can
create your favorite sound effects.
1 Press the A.PROC button for more than 3
seconds to enter Bass/Treble parameter setting
mode.
→ DIM → SUBW → BEEP → MUTE → SCR
DEMO ← AUX (AUX Mode Display Setting
∗
) ←
→ DIM → SUBW → BEEP → MUTE
DEMO ← AUX ← SCR ←