Filter
Top Products
23-EN
Installation
Caution
When you install this unit in your car, do not remove
the Detachable Front Panel.
If the Detachable Front Panel is removed during
installation, you might press too hard and warp the
metal plate that holds it in place.
1
Remove the Detachable Front Panel (refer to page
4). Slide mounting sleeve from main unit (see
"Removal" on this page).
Slide the mounting sleeve into the dashboard.
2
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (
∗
) already
attached to the vehicle's chassis.
NOTE
For the screw marked
**
, use an appropriate screw for
the chosen mounting location.
Metal plate
Detachable
Front panel
Mounting Sleeve
(Included)
Dashboard
CDA-7965/CDA-7864/CDA-7863/CDA-7862
Metal
Mounting
Strap
Chassis
Hex Nut (M5)
Bolt Stud
Ground Lead
∗∗
∗
CDA-7965/
CDA-7864/
CDA-7863/
CDA-7862
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming
from the left rear of the CDA-7965/CDA-7864/CDA-
7863/CDA-7862. Connect all other leads of the CDA-
7965/CDA-7864/CDA-7863/CDA-7862 according to
details described in the CONNECTlONS section.
Slide the CDA-7965/CDA-7864/CDA-7863/CDA-
7862 into the dashboard. When the unit is in place,
make sure the locking pins are fully seated in the
down position. This can be done by pressing firmly in
on the unit while pushing the locking pin down with a
small screwdriver. This ensures that the unit is
properly locked and will not accidentally come out
from the dashboard. Install the Detachable Front
Panel.
Removal
1 Remove the DETACHABLE FRONT PANEL.
2 Use a small screwdriver (or similar tool) to push
the locking pins to the "up" position (see above
drawing). As each pin is unlocked, gently pull out
on the unit to make sure it does not re-lock before
unlocking the second pin.
3 Pull the unit out, keeping it unlocked as you do
so.
<JAPANESE CAR>