Filter
Top Products
17-EN
* The illustration is for CDE-W235BT.
* The illustration is for CDE-W233R.
Adjusting Subwoofer Level/Bass Level/
Middle Level/Treble Level/Balance (Between
Left and Right)/Fader (Between Front and
Rear)/Loudness/Defeat
1
Press AUDIO/SETUP (CDE-W235BT only) or press AUDIO
(CDE-W233R only) repeatedly to choose the desired mode.
Each press changes the mode as follows:
SUBWOOFER
*1
BASS LEVEL
*2
MID LEVEL
*2
TRE LEVEL
*2
BALANCE FADER LOUDNESS
*2/*3
DEFEAT VOLUME
SUBWOOFER
*1 When the subwoofer mode is set to OFF, its level cannot be
adjusted.
*2 Adjustable only when DEFEAT is OFF.
*3 For details about loudness, refer to “Turning Loudness On/Off”
on page 18.
Note
• If no operation is performed for 5 seconds, the unit automatically
returns to normal mode.
2
Turn the Rotary encoder until the desired sound is
obtained in each mode.
By setting DEFEAT ON, previously adjusted settings of BASS,
MID, TRE LEVEL and LOUDNESS will return to the factory
defaults.
Audio Setup
You can flexibly customize the unit to suit your own preference and
usage. From the AUDIO SETUP menu, Audio Setting can be modified.
1
Press and hold AUDIO/SETUP (CDE-W235BT only) for at
least 2 seconds or press SETUP (CDE-W233R only) to
activate the SETUP mode.
2
Turn the Rotary encoder to select AUDIO, and then press
ENTER.
AUDIO GENERAL DISPLAY TUNER IPOD
BLUETOOTH
*1
*1 CDE-W235BT only.
3
Turn the Rotary encoder to select the desired sound
setting menu, and then press ENTER.
FACTORY EQ
*2/*3
LOUDNESS
*2
3BAND EQ
*2/*4
VOL LV ADJ
HPF
*2
SUBWOOFER SUBW LPF
*2/*5
SUBW PHASE
*5
SUBW SYS
*5
POWER IC
(e.g. Select SUBWOOFER)
*2 Adjustment cannot be performed when DEFEAT is set to ON.
*3 The FACTORY EQ’s setting value and 3BAND EQ’s setting
value are linkage.
*4 The FACTORY EQ’s setting value and 3BAND EQ’s setting
value are linkage. In step 3, three sound adjustment items (Bass,
Mid and Treble) can be selected in 3BAND EQ mode, turn the
Rotary encoder to select the desired item, and then press
ENTER to continue to step 4.
*5 These functions are inoperable when Subwoofer is set to OFF.
4
Turn the Rotary encoder to change the setting, and then
press ENTER.
(e.g. Select SUBW ON or SUBW OFF)
Sound Setting
/ENTER
Rotary encoder
AUDIO/SETUP
/ENTER
AUDIO
Rotary encoder
SETUP
Subwoofer +0 ~ +15
Bass level -7 ~ +7
Middle level -7 ~ +7
Treble level -7 ~ +7
Balance L15 ~ R15
Fader R15 ~ F15
Loudness ON/OFF
Defeat ON/OFF
Volume 0 ~ 35
Use steps 1 to 5 to select one of the setting modes to modify.
See the applicable section below for details about the
selected setting item.