Alpine IDA-X100 Car Stereo System User Manual


 
19-EN
Setting the Treble Control
You can change the Treble Frequency emphasis to create your own tonal
preference.
1
Press and hold IMPRINT for at least 2 seconds.
The Sound Setup screen is displayed.
2
Rotate the Double Action encoder to select the
“Treble Adjustment”, and then press
/ENTER.
3
Press /ENTER.
The F0 setting screen is displayed.
4
Press /ENTER.
5
Rotate the Double Action encoder to select the
desired treble center frequency, and then press
/ENTER.
10 kHz 12.5 kHz 15 kHz 17.5 kHz
Emphasizes the displayed treble frequency ranges.
6
Press and hold for at least 2 seconds to return to
normal mode.
If is pressed during setting, the unit returns to the previous item.
The function is inoperable when Defeat is set to ON.
You can adjust the treble level in normal mode. For details, refer to
“Adjusting Subwoofer/Bass/Treble/ Balance (Between Left and
Right)/Fader (Between Front and Rear)/Loudness/ Defeat” (
page 18).
After the setting, storing the setting contents on the unit is
recommended. For details, refer to “Storing the Audio Adjustment
Level” (
page 23).
Adjusting the High Pass Filter
The High Pass Filter on this unit can be adjusted to suit your personal
taste.
1
Press and hold IMPRINT for at least 2 seconds.
The Sound Setup screen is displayed.
2
Rotate the Double Action encoder to select “High
Pass Filter Adjustment”, and then press
/ENTER.
3
Rotate the Double Action encoder to select the
desired HPF frequency, and then press
/ENTER.
80 Hz 120 Hz 160 Hz off
4
Press to return to normal mode.
If is pressed during setting, the unit returns to the previous item.
The function is inoperable when Defeat is set to ON.
After setting, storing the setting contents is recommended. For how to
store, refer to “Storing the Audio Adjustment Level” (
page 23).
Turning Subwoofer ON/OFF
If an optional subwoofer is connected to the unit, make the following
setting.
When the subwoofer is on, you can adjust the subwoofer output level
(refer to page 18).
1
Press and hold IMPRINT for at least 2 seconds.
The Sound Setup screen is displayed.
2
Rotate the Double Action encoder to select
“Subwoofer”, and then press
/ENTER.
3
Rotate the Double Action encoder to select
ON/OFF, and then press /ENTER.
4
Press to return to normal mode.
If is pressed during setting, the unit returns to the previous item.
You can set the subwoofer output level in normal mode. Refer to
“Adjusting Subwoofer/Bass/Treble/ Balance (Between Left and
Right)/Fader (Between Front and Rear)/Loudness/ Defeat” (
page 18).
You can set the subwoofer system in SETUP mode. Refer to “Setting
the Subwoofer (Subwoofer System)” (
page 24 ).