Filter
Top Products
12-EN
Settings/Adjustments
(factory default)
*1 When centre is set to subwoofer, it is not
displayed.
*2 When centre is set to subwoofer, it becomes
Sub.W(L).
*3 When centre is set to subwoofer, it becomes
Sub.W(R).
5 Turn the Rotary encoder to select the
frequency, then press the ENTER button.
Adjustable frequencies
Front/Rear/Centre: 20Hz~20kHz (1/3 octave
step)
Sub.W: 20Hz~160Hz (1/3 octave step)
6 Turn the Rotary encoder to adjust the level (± 9
dB in steps of 1 dB), then press the ENTER
button.
7 Repeat steps 5 and 6 to adjust other
frequencies.
8 To adjust other channels, press the CHANNEL
button to return to step 4.
* The difference in the sound when the defeat
mode is turned off (adjusted graphic
equalizer settings) and on (default values)
can be checked as follows:
1) While in the adjustment mode, press and
hold the G.EQ button for at least 2 seconds.
2) Press the G.EQ button to switch the defeat
mode on and off and listen to the difference
in the sound.
3) To quit, select the desired setting, then press
the ENTER button.
Note that if you press the ENTER button with
the defeat mode turned on, the adjustments
are reset to the defeat on status (the default
values).
9 Once the adjustments are completed, press the
G.EQ button.
NOTES
• When the speaker is set to the “OFF” mode, the
graphic equalizer for that speaker is ineffective.
Refer to “Setting the speakers” (page 4).
• Check the playable frequency ranges of the connected
speakers before making the equalizer adjustments. If
the speaker’s playable frequency range is 55 Hz to 30
kHz, for example, adjusting the 40 Hz or 20 Hz band
has no effect. Additionally, you may overload and
damage the speakers.
• After making the settings, we recommend storing
them in the memory. For instructions, see page 28.
• When graphic EQ is adjusted, the adjustment for
parametric EQ becomes ineffective.
CHANNEL
ENTER
G.EQ
P.EQ
Rotary encoder
Graphic equalizer adjustments
The graphic equalizer allows you to modify the
sound using 31 bands each for the front (left and
right), rear (left and right) and centre speakers.
An additional 10 bands are available for the
subwoofer. This allows you to customize the
sound to suit your taste.
1 Check that the defeat mode is off.
(See page 28.)
2 Press the G.EQ button to set the graphic
equalizer mode.
3 Press and hold the CHANNEL button for at least
2 seconds and select “L and R (LR)” or “L or R”.
L and R (LR):Sets the same adjustment values
for the left and right channels.
L or R: Different adjustment values can be
set for the left and right channels.
4 Press the CHANNEL button to select the desired
channel, then press the ENTER button.
When “L and R (LR)” is selected:
When “L or R” is selected:
Front Rear Center
Sub. W
*1
Rear R
Center
Sub. W
Front L Front R
Rear L
*2*3
31– .E
Q
Front LG
– 9dB
12.5kHz
L and R (LR) L or R