Filter
Top Products
20-EN
* If DOLBY PL II MUSIC is selected, the
centre width can be adjusted with following
operations.
This function offers the optimum vocal position
by adjusting the centre channel position
between the centre speaker and the L/R
speaker. (The adjustments established in
“Adjusting the acoustic image” (page 24) are
ineffective while this function is activated.)
1) After selecting DOLBY PL II MUSIC, within
15 seconds, press and hold the
PLII/
REAR FILL button for at least 2 seconds.
2) Turn the Rotary encoder to select “Center
Width ON” or “Center Width OFF”, then
press the ENTER button.
When the setting is turned ON, the optimum
vocal position is offered by adjusting the
centre channel position between the centre
speaker and the L/R speaker.
3) Turn the Rotary encoder to adjust the level,
then press the ENTER button.
The level can be adjusted between 0 to 7.
When the level increases, the centre channel
position moves from the centre speaker
position to both side.
4) After the setting, press and hold the
PLII/REAR FILL button for at least 2
seconds.
NOTES
• Avoid stopping, pausing, switching the disc, cueing,
fast-forwarding or switching the audio channel of the
player while making this adjustment. The setting is
cancelled if the decode mode is switched.
• This adjustment is ineffective if the centre speaker is
set to “OFF” or “Sub.W” in the speaker setup
settings.
2 Once the settings are completed, press the DISP
button.
NOTES
• This function only works with two-channel signals.
This operation is ineffective when 5.1-channel DTS
or Dolby Digital signals are input.
•“REAR FILL” function
Depending on the input signals, the sound may only
be output from the front speakers. In this case, the
“REAR FILL” function can be used to output signals
from the rear speakers as well.
• If the setting of REAR FILL is made when REAR MIX
is ON, sound is unchanged in the rear fill setting
because REAR MIX is given priority during 2
channel decoder other than linear PCM.
• For linear PCM signals, the voice is output from the
rear speaker regardless of the REAR FILL and REAR
MIX setting.
• Once the settings are made, we recommend storing
them in the memory. See page 28 for instructions.
Using Dolby Surround
Using the Pro Logic II mode
With the PXA-H701, Pro Logic processing can be
conducted on the music signals recorded on two
channels to achieve Dolby Pro Logic II surround
sound. For two-channel Dolby Digital and DTS
signals, there is also a “REAR FILL” function for
outputting the signals of the front channel to the
rear channel.
1 Press the PLII/REAR FILL button and select
the desired mode.
The setting mode is cancelled if no operation is
performed within 15 seconds after the mode is
selected.
DOLBY PL II MOVIE: Suits the stereo TV
shows and all programs
encoded in Dolby
Surround. It improves
the sound field
directivity to near that of
discrete 5.1-channel
sound.
DOLBY PL II MUSIC: Can be used for all
stereo music
recordings, and
provides a wide, deep
sound field.
REAR FILL
OFF
DOLBY PL II MOVIE DOLBY PL II MUSIC
PLII/
REAR FILL
ENTER
DISP
Rotary encoder