Alpine TME-M790 Car Video System User Manual


 
6-EN
Switching Display Modes
Viewing the switching display modes
To watch a video source, your vehicle must be
parked with the ignition key in the ACC or ON
position. To do this, follow the procedure below.
1. Push the foot brake to bring your vehicle to a
complete stop at a safe location. Engage the
parking brake.
2. Keep pushing the foot brake and release the
parking brake once then engage it again.
3. While the parking brake is being engaged the
second time, release the foot brake.
NOTE
For automatic transmission vehicles, place the
transmission lever in the Park position.
The video lock-out system is now disabled.
Unless ignition is turned OFF, this mode can be
reactivated by simply engaging the parking
brake, without performing the entire procedure
above (1 through 3).
If the ignition is turned OFF position, you must
perform the entire procedure above.
NOTE
Trying to access the switching display modes while
driving will display the warning - PICTURE OFF
FOR YOUR SAFETY.
Basic Operations
DISP
MODE 1 MODE 2 MODE 3 MODE 4
(WIDE) (ZOOM) (CINEMA) (NORMAL)
MODE 1 (WIDE)
MODE 2 (ZOOM)
1 Press and hold the DISP button for at least 2
seconds. Each press changes the display modes
as follows:
Stretches the normal image evenly in a
horizontal direction so that it is displayed on the
entire screen.
Stretches the normal image evenly in a
horizontal direction so that it is displayed on the
entire screen. The stretching ratio increases the
closer to the left or right edge of the screen.