Filter
Top Products
19-EN
PRECAUTIONS
• Be sure to disconnect the cable from the (–) battery
post before installing your TME-S370. This will
reduce any chance of damage to the unit in case of
a short-circuit.
• Be sure to connect the color coded leads according
to the diagram. Incorrect connections may cause
the unit to malfunction or damage to the vehicle’s
electrical system.
• When making connections to the vehicle’s
electrical system, be aware of the factory installed
components (e.g. on-board computer). Do not
tap into these leads to provide power for this unit.
When connecting the TME-S370 to the fuse box,
make sure the fuse for the intended circuit of the
TME-S370 has the appropriate amperage. Failure
to do so may result in damage to the unit and/or
the vehicle. When in doubt, consult your ALPINE
dealer.
• The TME-S370 uses female RCA-type jacks for
connection to other units having RCA connectors.
You may need an adaptor to connect other units. If
so, please contact your authorized ALPINE dealer
for assistance.
• The Display must be completely retracted in the
casing when installing. If it is not, problems may
occur.
Mounting Options
Mounting the Monitor on the Dashboard
Using a Bracket
The bracket is not included. Ask your dealer to make
a custom bracket that is suitable for your vehicle.
1 Mount the bracket using the screws
(M5 x 8).
2 Mount the bracket on back side of the
monitor.
3 Mount the monitor with bracket attached in
the car.
Attaching the Monitor and Stand
CAUTION
Do not install the monitor near the front
passenger seat air bag system.
You can purchase an aftermarket monitor stand.
Mount the monitor by following the installation
manual for the monitor stand.
Mounting Monitor at Headrest
Ask your dealer to install the headrest cup kit or
headrest pole bracket.
290533_TME370_r13.indb E19290533_TME370_r13.indb E19 7/29/09 1:29:16 PM7/29/09 1:29:16 PM