Filter
Top Products
21-EN
1 ACC (+12V) Red Connect to vehicle accessory / ignition
2 GND Black Connect to vehicle ground line
3 REMOTE White/Brown Remote out for controlling peripherals
4 M-CONT White/Pink “Monitor Control” activate while S3 remote function is used
5 REVERSE Orange/White Switch to rearview camera screen
6 FOOT BRAKE Yellow/Black Enables displaying video or operating setup (For front use)
7 HAND BRAKE Yellow/Blue Enables displaying video or operating setup (For front use)
8 PARKING BRAKE Yellow/Blue Enables displaying video or operating setup (For rear use)
For USA, parking brake wire pin is for rear seat entertainment use. It is not
connected at factory for US model. The wire pin is included in a bag with
a caution note.
For other regions, parking brake wire pin is connected at factory. Foot and
hand brake wires are not necessary.
9 POWER CONNECTOR
= RGB CABLE
A CAMERA INPUT TERMINAL
B S-VIDEO CABLE
C RCA EXTENSION CABLE
Lock-out Function
To watch AUX device or operate setup functions, the Lock-out needs to be disabled. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe location. Engage the hand brake.
2 Keep pushing the foot brake and release the hand brake once then engage it again.
3 When the hand brake is engaged for the second time, release the foot brake.
Now, the locking system for the AUX mode operation has been released. Engaging the hand brake can
reactivate the AUX mode, as long as the car's ignition has not been turned off. It is not necessary to repeat the
above procedure (1 through 3), of "Lock-out Function".
• If you try to activate the auxiliary device while driving, the display will show the warning-Picture Off For Your
Safety.
290533_TME370_r13.indb E21290533_TME370_r13.indb E21 7/29/09 1:29:16 PM7/29/09 1:29:16 PM