Alpine TME-S370 Car Stereo System User Manual


 
4-EN
Location of Controls
1
2
345
67
8
1 Remote IR Receiver
The IR receiver receives the remote IR command
from the remote controller of connected devices.
2 Ambient Light Sensor
Changes the LCD backlight and the soft-touch
key backlit automatically, when the surrounding
brightness changes.
3 Volume Buttons
Adjust the volume level by pressing the or
buttons. AUX and Navigation independently
controls volume.
-For details, refer page 12.
4 SOURCE Button
Returns to Source Select screen.
5
(POWER)/Mute
Turns the monitor power On and Off.
The monitor power turns Off when press and
hold the power button for 2 seconds. Power
button changes to red in standby mode.
Turns Mute on when press the power button,
when the unit is turned on.
The mute icon appears on the screen.
6 Built-in Speaker
Outputs sound for AUX and Navigation guidance.
7 AMPS Mounting Hole
Universal AMPS accessory is available in any
third party dealer.
8 Locking Connector to the hideaway box
Connects to the hideaway box.
Make sure to lock properly.
Turning Power On and Off
1 Press POWER to turn on the unit.
2 Press and hold POWER for 2 seconds to
turn off the unit.
Some operations cannot be performed while the
vehicle is in motion. In order to operate, enable lock-
out function. See page 21 for details.
Adjusting the Volume and Mute
1 Adjust the volume level by pressing or
.
Turn the volume up to turn Off mute.
If “Changing Sound Output (HU Vol. Control)”
(page 12) is set to on, you can adjust HU speaker
volume.
The volume control bar disappears after 3 seconds
once the volume operation is completed.
The volume bar does not indicate when the HU
volume control mode is on.
Getting Started
290533_TME370_r13.indb E4290533_TME370_r13.indb E4 7/29/09 1:29:12 PM7/29/09 1:29:12 PM