Filter
Top Products
SPECIAL APPLICATION
400-0422-001
13
Example:
Send the command [HUE12] to set the output
hue to 12.
24. [HUE]
This command displays the current hue level
and makes the hue function active for
adjustments. See the [+] and [-] commands for
adjustment details.
NOTE: The Hue adjustment does not apply to
Component Video.
Command Format: [HUECi]
Ci = Unit ID (i = # from 0 to 99)
Example:
Send the command [HUE]. The unit will display
the current hue level, for example “[12]”. The
hue feature is now active. The [+] and [-]
commands may be used to adjust the hue.
25. [VLOA]
This command sets the output audio level to an
absolute value. This value will apply only to the
audio output of the selected input. Each input
type has its own audio level setting.
Command Format: [VLOAnCi]
n = Level (n = # from 00 to 32)
Ci = Unit ID (i = # from 0 to 99)
Example:
Send the command [VLOA32]. This will set the
output volume to maximum.
26. [SEL]
This command displays the current audio level
setting and makes the audio function active for
adjustment using the [+] and [-] commands.
Each input selection has its own audio gain
level.
Command Format: [SELCi]
Ci = Unit ID (i = # from 0 to 99)
Example:
The AP445-401 has the S-Video input selected
and the gain level is set to the maximum level of
32. Send the command [SEL] and the unit will
display “[32]” and make the gain adjustment
active. The [+] and [-] commands may now be
used to adjust the audio level. The audio level
for other inputs will not change.
27. [MODEN]
This command turns the Digital Noise Reduction
feature on and off.
Command Format: [MODENpCi]
p = Noise Reduction (0 = OFF and 1 = ON)
Ci = Unit ID (i = # from 0 to 99)
Example:
Send the command [MODEN1] to turn on digital
noise reduction for the AP445-401.
28. [MODEA]
This command sets the aspect ratio between
wide and standard formats.
Command Format: [MODEAmCi]
m = Aspect Ratio (m = 1 or 2)
1 = Wide 16:9
2 = Standard 4:3
Ci = Unit ID (i = # from 0 to 99)
Example:
Send the command [MODEA1] to set the aspect
ratio to wide format on the AP445-401.
29. [FREEZ]
This command is used to freeze the image
displayed on the display.
Command Format: [FREEZpCi]
p = Freeze value (0 = OFF and 1 = ON)
Ci = Unit ID (i = # from 0 to 99)
Example:
Send the command [FREEZ1] to freeze the
image generated by the AP445-401.