Filter
Top Products
13
High Frequency Driver replacement continued:
6
6
Four bolts and eight washers may be
removed from the driver using the 8mm
combination wrench. Turn counter-
clockwise to loosen and remove,
clockwise to tighten. The other three
are located around the horn assembly.
Notice that the fl at washer is on the
bottom, followed by the locking washer,
and fi nally the bolt.
7
7
Keep the four bolts, four locking washers,
and four fl at washers in a safe place.
8
8
The horn assembly should easily lift right
off of the high frequency driver. Place
the new high frequency driver (part
#0008093) where the old one was. Follow
the same steps as above, but backwards
8 to 1. Power up the S408 and the new
driver should now be pumping out those
highs again. Fantastic, you just replaced
a high frequency driver!
fl at washer
fl at washer
bolt
bolt
locking washer
locking washer