Filter
Top Products
29
Entry of objects and liquids
Never push objects of any kind into your receiver through openings as they may touch
dangerous voltage points or short-out parts that could result in fire or electric shock.
Never spill liquid of any kind on your receiver.
Placement and mounting
Do not place your receiver on an unstable or uneven surface. Your receiver may fall,
causing serious injury to a child or adult and serious damage to your receiver.
Risk of fire or scorching
Never place open flame sources, such as lighted candles, on or adjacent to your
receiver.
SAVE THIS INFORMATION FOR FUTURE REFERENCE
Safety aspects of connections
For full details about the rear panel connections, see “Connecting the Receiver” on
page 9.
Connecting
Do not connect your receiver (or any other equipment such as a TV or VCR) to the
power supply until you have properly connected all the other cables. Your receiver is
designed for use only with the supplied power supply unit.
On the power supply unit there is a label that specifies the correct AC power supply
input for it. Do not connect the power supply unit to any supply other than this.
Always connect the 12 volt connector from the power supply unit to your receiver
before you insert the AC power connector from the power supply unit into the wall AC
outlet.
Disconnecting
To disconnect power from your receiver, always detach the power supply unit from the
wall AC outlet (rather than remove the 12 volt connector from your receiver).
You must install your receiver near to the wall AC outlet, which should be easily
accessible.
If you are in any doubt about the power supply unit, its plug or its connection, consult a
qualified electrician.