Filter
Top Products
31
Compliance Information
This section contains regulatory and compliance information about the set-top box.
Regulatory information
CAUTION: Do not attempt to modify your set-top box without written authorization from the
manufacturer. Unauthorized modification could void your authority to operate your set-top box.
Trade Name: Pace Americas
Responsible Party: 2Wire, Inc. DBA Pace Americas
Address: 1764 Automation Parkway, San Jose, CA 95131
Phone: (408) 428-9500
Declaration of Conformity
FCC / Industry Canada Compliance
This device has been tested and certified as compliant with the regulations and guidelines set
forth in the Federal Communication commission - FCC part 15 and Industry Canada - ICES-003
Radio and telecommunication regulatory requirements / Cet appareil numérique de la classe B
est conforme à la norme NMB-003 du Canada.
Manufacturer: 2Wire, Inc. DBA Pace Americas
Model(s): IPH8005, IPH8010, IPH8110
Part 15 of FCC Rules
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux normes CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, you are encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit that is different from the circuit used by the
receiver.
• Consult your dealer or an experienced radio/TV technician for help.