Filter
Top Products
1010
1010
10
OPEROPER
OPEROPER
OPER
AA
AA
A
TT
TT
T
ING INSTRUCING INSTRUC
ING INSTRUCING INSTRUC
ING INSTRUC
TT
TT
T
IONSIONS
IONSIONS
IONS
cs DISC EJECT ( )
Disc play is stopped and the disc is ejected
when the front panel is folded down and this
button on the rear of the panel is pressed.
Radio or CD changer operation will automatically
resume depending on which mode was in
operation prior to disc play. If the disc is
not removed from the unit within 10 seconds
of being ejected, it will automatically be re-
loaded into the unit to prevent it from being
accidentally damaged (
IN will appear
on the display panel to indicate that a disc
is loaded in the player). Play of the disc
can be resumed by using the Mode Selector
bt to choose CD player function.
ct TIME/FREQUENCY SELECTOR (T/F)
During radio operation, press this button to
call the time display on the incorporated
quartz clock. The display will return to the
radio frequency indication after 5 seconds.
During CD player operation, the first press
of the button will call the track elapsed time
on the display panel. A second press will
call the time display. During CD changer
operation the first press of the button will
call the time display. A second press will
call the disc slot number and track number
in play. In either case, the display will return
to the disc indication after 5 seconds.
cu EQUALIZER BUTTON (EQ)
The EQ button applies preset sound effects
to the unit’s audio output signal. The EQ
button, when pressed, will activate one of
three operating modes (ROCK, CLAS, or
POP). When the EQ function is active the
bass and treble levels cannot be changed.
When the EQ function is not active, the unit
returns to the user set bass and treble levels.
dl THEFT-DETERRENT LED
Located on the chassis behind the front
panel, a light-emitting diode (LED) will flash
when the panel is physically removed. The
flashing light serves as a visual warning to
the would-be thief that the unit has been
disabled by removal of the front panel.
dm RESET BUTTON
circuitry and should only be activated under
the following circumstances as it will erase
the time and pre-set memories:
1.Upon initial installation after all wiring is
completed.
2.If there is a malfunction of any of the
switches, on the unit, pressing the
RESET button may clear the system and
return to normal operation.
dn REMOTE SENSOR
The sensor to detect the infrared signal from
the wireless remote control is located behind
this lens. For optimum operation of the
remote control, always aim the control at
this sensor.
do FRONT PANEL RELEASE BUTTON
(OPEN)
This button is used to release the
mechanism that holds the front panel to the
chassis. To detach the front panel, press
the button so that the paneldrops to the
lowered position. Grasp the panel at the
middle and pull it off of the chassis. After
removing the panel, push the metal plate
back up to the vertical position. To re-attach
the panel, press it straight onto the chassis
until the mechanism locks it into place.