Filter
Top Products
the side of the tape being played, the unit will automatically change
direction of play as shown by the arrow indications on the display
panel.
NOTE: Observe cassette operation cautions in the Care and
Maintenance section of this manual.
bs FAST -FORWARD BUTTON ( FF )
Pushing the Fast-Forward button will cause the tape to move
rapidly in forward direction of play (tape direction arrow on the
display panel will flash). To stop Fast-Forward movement, lightly
push the Rewind Button bt until the Fast-Forward button disen-
gages.
bt REWIND BUTTON (REW)
Pushing the Rewind button will cause the tape to move rapidly in
the reverse direction of play (tape direction arrow on the display
panel will flash). To stop Rewind movement, lightly push the
Fast-Forward button bs until the Rewind button disengages.
bu PROGRAM SELECTOR
To manually reverse tape direction and play the other side (pro-
gram) of the cassette, lightly push both the Fast-Forward and
Rewind buttons bs and bt at the same time. The change of
direction will be shown by the arrows on the display panel.
cl EJECT BUTTON ( )
Tape playback is stopped and the cassette is ejected by press-
ing this button. Radio or CD changer operation will automatically
resume when the cassette is ejected, depending on which mode
-4-
bp STA TION PRE-SET MEMORIES
To set any of the 6 pre-set memories in each band, use the follow-
ing procedure:
1. Turn the radio on and select the desired band.
2. Select the first station to be pre-set using the Manual Up/Down
orAutomatic Seek Tuning Controls bm .
3. Press the pre-set button to be set and continue to hold it in.
After approximately 2 seconds, the volume will be momentarily
muted, indicating that the station is now set into that pre-set
memory position. The station can now be recalled at any time
by pressing that button.
4. Repeat the above procedure for the remaining 5 pre-sets on
that band and for the other 4 bands on the unit.
bq LIQUID CR YST ALDISPLA YP ANEL
The Liquid Crystal Display (LCD) panel displays the frequency,
time, and activated functions.
NOTE: It is a characteristic of LCD panels that, if subjected to
cold temperatures for an extended period of time, they
may take longer to illuminate than under normal condi-
tions. In addition, the visibility of the numbers on the LCD
may slightly decrease. The LCD read-out will return to
normal when the temperature increases to a normal range.
br CASSETTE DOOR
Hold the cassette with the exposed tape edge to the right and
insert it into the tape door. Depress fully until the cassette is en-
gaged and begins playing as shown by the “CAS TAPE” indica-
tion on the display panel. When the cassette reaches the end of