Filter
Top Products
SETTING THE CLOCK
1. Turn the vehicle ignition and radio “on”.
2. Press and hold the Time/Frequency Selector button cn approximately 2 seconds until the time
display begins flashing on the display panel.
3. Within 5 seconds after the time display begins flashing, press the Manual Down Tuning button
( ) to adjust the hours and the Manual Up Tuning button ( ) to adjust the minutes to the correct
time.
4. Five seconds after the last hour or minute adjustment is made, the time will be set in the unit and
normal operation can resume.
FREQUENCY STEP SWITCH
This unit is supplied pre-set at the factory for reception of North American radio stations (10 KHz.
channel spacing on AM/200 KHz. spacing on FM). Use in other areas in the world may require
different channel spacing. A switch on the bottom of the chassis allows selection of 9 KHz. AM/100
KHz. FM channel spacing. Slide the switch to the appropriate position using a small screwdriver
blade. The Re-Set button cp on the front of the chassis must then be pressed to activate the change
of channel spacing.
-7-