Filter
Top Products
-5-
was in operation prior to cassette play.
NOTE: Never leave a cassette engaged in the player when not
in use. Doing so can cause damage to the cassette
and/or mechanism of the unit. Always press the eject
button and remove the cassette before removing the
detachable front panel.
cm T APE MODESELECTOR (TAPE)
If a cassette is loaded in the unit but radio or CD changer opera-
tion has been selected, press this button to return to tape play.
cn TIME/FREQUENCY SELECTOR (T/F)
This unit can be set so that either the clock time or radio fre-
quency/cassette/CD changer functions will normally appear on
the display panel. Pressing the Time/Frequency Selector button
when the radio frequency, cassette mode, or CD changer track/
disc indication is shown will change the display to show the time.
The time will then be the priority setting and the display will au-
tomatically return to time display 5 seconds after any other ra-
dio, cassette, CD changer, or audio function display.
If the unit is set to time display priority, pressing the Time/Fre-
quency Selector button will change the display to show the radio
frequency/cassette mode/CD changer indication and this will then
become the priority setting to which the display automatically
returns 5 seconds after any other function is activated.
coTHEFT-DETERRENT L.E.D.
Located on the chassis behind the front panel, a light-emitting
diode (L.E.D.) will flash when the panel is removed. The flashing
light serves as a visual warning to the would-be thief that the unit
has been disabled by removal of the front panel.
cp RE-SET BUTT ON
A Re-Set button is located on the front of the chassis (front panel
must be removed to access the button). The re-set circuitry is
provided to protect the microprocessor circuitry and should only
be activated under the following circumstances as it will erase
the time and radio station pre-set memories.
1. Upon initial installation after all wiring is completed.
2. After the position of the frequency step switch on the bottom
of the chassis has been changed.
3. If there is a malfunction of any of the switches on the unit,
pressing the Re-Set button may clear the system and return
to normal operation.