Filter
Top Products
General functions
77
ENGLISH DEUTSCHFRANÇAISITALIANO
NEDERLANDS
Insert the CD with its print-
ed side uppermost into the CD
drive
C until you feel some re-
sistance.
The CD is automatically drawn
in and the control panel closes.
This CD can now be selected as
audio source.
Note:
As long as the CD is in the
drive, the device stores track
and playing time of the CD
played last, and after calling up
the audio source, the playback
starts at the position where it
was interrupted.
Inserting an MMC/SD card
Note:
Blaupunkt cannot guarantee
the correct functioning of all
MMC/SD card available on the
market and, for this reason,
recommends the use of MMC/
SD cards manufactured by
"SanDisk" or "Panasonic". The
cards must be formatted using
the FAT16 or FAT32 fi le system
and contain MP3 or WMA fi les.
Remove the control panel as
described on page 9.
Insert the MMC/SD card in the
card slot
D until it engages.
The contacts of the card must
point down and to the rear.
➔
➔
➔
Attach the control panel as
described on page 9.
This MMC/SD card can now be
selected as audio source.
To remove the MMC/SD card:
Remove the control panel as
described on page 9.
Push on the MMC/SD card
until it disengages.
Pull the MMC/SD card out of
the card slot
D.
Connecting the USB
medium
To be able to connect a USB stick
or a USB hard disk, the supplied
USB cable must be connected
to the rear side of the device be-
fore the installation as described
in the installation instructions.
This cable can be routed, for ex-
ample, to the glove compartment
or a suitable place of the center
console.
Note:
Always switch off the device
before connecting or discon-
necting your USB medium!
Connect the USB medium to
the USB cable that is routed
from the rear side of the de-
vice.
The USB medium can now be
selected as audio source.
➔
➔
➔
➔
➔
03_BA_Casablanca_1_ENG.indd AllgFkt7703_BA_Casablanca_1_ENG.indd AllgFkt77 31.05.2006 11:15:37 Uhr31.05.2006 11:15:37 Uhr