Filter
Top Products
General functions
76
When connecting a hard disk,
please note that the maximum
current load on the USB port
must not exceed 800 mA.
Adjusting the volume
WARNING!
Danger from excessive
volume!
Excessive volume can damage
your hearing and you may fail to
hear acoustic warning signals!
Do not increase the volume
while the device changes the
CD in the CD changer or the
audio source.
Always set the device to a
moderate volume.
Turn the volume control
5.
The current volume is shown
in the central area
B of the
display and used for all audio
sources.
Note:
To preset the volume of traffi c
announcements (TRAFFIC), a
connected telephone (PHONE)
and the signal tone (BEEP), see
pages 115 and 116.
➔
➔
➔
Muting the device
The device can be muted as fol-
lows:
Briefl y press the On/Off but-
ton
4.
The display shows "MUTE".
To cancel the mute function:
Briefl y press the On/Off but-
ton
4 again or turn the volume
control
5.
Operation with telephone
If a hands-free system is installed
in your vehicle or your cell phone
is connected to the device via a
Bluetooth adapter, the device re-
sponds as follows to incoming or
outgoing telephone calls:
The voice of the person calling
you is played back via the loud-
speakers of the vehicle.
The display shows "PHONE
CALL".
The currently playing audio
source is muted.
During the telephone call, you
change the volume of the tele-
phone call by means of the vol-
ume control
5.
Traffi c announcements (TA) are
not automatically shown.
➔
➔
•
•
•
•
•
02_BA_Queens_1_GB.indd 7602_BA_Queens_1_GB.indd 76 13.09.2007 16:07:52 Uhr13.09.2007 16:07:52 Uhr