Filter
Top Products
62
the master code for the unit, which you will
find in the radio pass.
Always keep the radio pass in a safe
place. Do not leave it in your vehicle.
Training the new KeyCard
• Insert the new KeyCard into the unit
and lock the operating panel into posi-
tion.
• Switch the unit off.
• Press TU and ST1 at the same time
and switch the unit on. “0000” will ap-
pear in the display.
• Now use the rocker switch to enter the
four-digit master code from the radio
pass:
/ - Enter digits
(press as often as required)
<< >> - Select the entry position.
• Press ENT after you have entered the
correct master code.
The new KeyCard has been accepted when
the unit will begin to play.
First-time installation
After you switch on the unit for the first time
or when the unit has been disconnected from
the power supply, “INSTALL” will appear in
the top line of the display.
In this menu you can enter/alter the follow-
ing:
Time, owner ID, reset to default settings,
ignition connection on/off, internal output
stage on/off.
Activating the Install menu
You can activate the Install menu at any
time.
• Just hold DSC pressed down for 4 sec.
Closing the Install menu
• Press EXIT.
Setting the clock
The clock is set automatically when the ra-
dio is tuned into an RDS station which has
the CT function (clock time).
If this signal is not available, the audio sys-
tem will attempt to receive the DCF-77 time
signal (atomic clock) to correct the time the
next time it is switched off. The display will
indicate “CLK Sync” while it is synchronis-
ing the time.
If you would like to set the clock manually,
• press CLK, the field to be adjusted will
flash in the top line of the display
(hours or minutes)
• Press << / >> to switch fields if neces-
sary and use
/ to enter the correct
time.
Once you have completed the setting,
• press ENT, the INSTALL menu will re-
turn to the display.
For more information on the clock, please
refer to the section on the “Clock - Time”.
Entering your Owner Identifica-
tion
Use this function to enter six lines with eight
characters each as your proof of ownership.
To do so
• press O-ID, the first entry position will
flash in the top line of the display.
Use
/ to select the letters, digits and sym-
bols, use << / >> to select the entry posi-
tion.
S.FrancisRDM169 gb 95%® 29.05.2002, 10:56 Uhr62