Filter
Top Products
6.
CAUTIONS
ON
WIRING
1.
Be sure to turn the power off before wiring.
2. Be particularly careful where you route the
wires.
Keep them well away from the engine, and
exhaust pipe, etc. Heat may damage the
wires.
3.
If the fuse should blow, check to see if the
wiring
is
correct.
If a fuse is blown, replace it with a new one of
the same amperage rating as the original
(15A FUSE).
4.
To replace the fuse, remove the old fuse
of
the power supply cord and insert the new one.
(Figure
8)
Note:
• There are various types
of
fuse holder. Do
not
let
the battery side touch other metalparts.
ACAUTION .
After the connection, fix the cord by a clamp
or insulation tape for protection.
Fuse holder
Fuse (15A FUSE)
Figure 8
VRX485VO/MAX385VD 42