Filter
Top Products
Back to Contents Page
Setting Up the Monitor
Dell™S1709WFlatPanelMonitorUser'sGuide
Attaching the Base
Connecting Your Monitor
Organizing Your Cables
Attaching the Optional Dell Soundbar
Removing the Base
Attaching the Base
Connecting Your Monitor
Connecting Your Monitor Using a VGA Cable
NOTE: The base is detached when the monitor is shipped from the factory.
To attach the base of the stand to the monitor stand:
1.
Place the monitor on a stable flat table.
2.
Align the groove on the stand base to the raiser on the monitor.
3.
Turn the thumb screw clockwise to tighten the monitor stand base and raiser.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions.
1.
Turn off your computer and disconnect the power cable.
2.
If you are using the monitor, connect the blue VGA cable to the blue connector on the computer and monitor.