Filter
Top Products
23
ENGLISH
Advanced versionSimple version InformationBasic version
Adjusting the picture quality (Picture control)
You can adjust the picture quality to your liking.
The adjusted values can be stored in Memory 1 through Memory 5.
1
Press PICTURE ADJUST.
•The currently set status is displayed.
0
Memory1
3DNR
BNR
MNR
Contract
Brightness
Gamma Correcti....
2
Press ui to select a memory number to be used, and then
press ENTER.
3
Press ui to select an item then press ENTER or p.
4
Change the setting with ui.
•Refer to the table on the right for information on the different settings.
To finalize picture adjustments
Press PICTURE ADJUST after adjusting.
•ThePopupmenuofthepictureadjustmentsisdisappearedonthescreen.
The picture adjustment settings are retained in memory even after the power is turned off.
Setting items Setting contents Default
3DNR
Reduces noise in the entire picture.
0 – +3 0
BNR
Reduces the block noise generated by digital
processing.
0 – +3 0
MNR
Reduces the noise around the outline of an object
generated by digital processing.
0 – +3 0
Contrast
Adjusts picture contrast.
–6 – +6 0
Brightness
Adjusts picture brightness.
0 – +12 0
Gamma Correction
Changes the amount of gamma correction to
adjust overall brightness of a picture.
Make Dark(–) / bright(+)
section easier to see.
–4 – +4 0
Sharpness
Adjusts picture sharpness for the higher
frequency range.
–6 – +6 0
Hue (color tone)
Adjusts the green and red color balance.
–6 ~ +6 0
Chroma Level
Adjusts the color density.
–6 – +6 0
Setup Level (
z
1)
Adjusts the black areas of the image.
0 IRE
7.5 IRE
7.5 IRE
(z1) : Effective only for the 480i video signal from the video output terminal and the component video
output terminal.
1.DBP-1611E3_ENG_0702.indd 23 2010/07/05 17:24:20