Denon RCD-N7 Car Stereo System User Manual


 
6
ENGLISH
Protection circuit
The protection circuit is be activated in the following situations:
• If the speaker cable wire touches the rear panel or screws or if the
speaker cable wire touches the speaker cable’s + and – sides are
touching
• If the surrounding temperature is extremely high
• If the inside of the amplifi er gets hot to extended use at a high
output
If this happens, unplug the power cord, then check the connections
of the speaker cables and input cables. If the unit becomes very hot,
wait for it to cool off and improve the ventilation around it. After doing
this, plug the power cord back in.
If the protection circuit is activated even though there are no problems
with the ventilation around the unit or in connections, the unit may
be damaged. Turn off the power and then contact a DENON service
center.
Connecting recording components
CD recorder / MD recorder
Cables used for connections
Audio cable (sold separately)
Stereo
pin-plug cable
R
L
R
L
(White)
(Red)
COAX.
75ǡ
LOOP
ANT.
ETHERNET
NETWORK
FM
AM
ANTENNA
TUNER
L
R
AUX OUT AUX IN 1 AUX IN 2
PREOUT
SUBWOOFER
AUX IN 3
(OPTICAL)
A
RCD-N7W
3- 3-
*/ 065
"6%*0
"6%*0
R
L
R
L
R
L
R
L
CD recorder /
MD recorder /
Tape deck
Connecting a TV
• Select the connector to use and connect the device.
• To listen to TV audio through this device, use the optical digital
connection.
Cables used for connections
Audio cable (sold separately)
Stereo
pin-plug cable
R
L
R
L
(White)
(Red)
Optical cable
COAX.
75ǡ
LOOP
ANT.
FM
AM
ANTENNA
TUNER
AUX IN 2
AUX IN 3
(OPTICAL)
3-
065
"6%*0
"6%*0
R
L
R
L
015*$"-
065
TV
NOTE
Other digital audio signals than 2 channel linear PCM cannot be input
through AUX IN 3 (OPTICAL) terminal of this unit.
When you try to input digital audio signals other than 2 channel linear
PCM to this unit, set the digital audio output setting of the TV to 2
channel PCM.
For details, see the operating instructions of the TV.
Speaker connections