Filter
Top Products
36
ESN security operating procedure
[FUNC] button
Button [5] Button [2]
How to operate the ACC security
ACC security involves using Memory Stick security to record a
security code, and then when the ignition switch is turned to OFF
and back to ACC, the operation of all buttons is disabled.
Check that the Power is OFF.
1
Once a security code has been recorded, press button
[5] and the [FUNC] button simultaneously for more than
two seconds.
2
The ACC security function will be activated. Press button [5]
and the [FUNC] button simultaneously for two seconds or more
again to cancel the ACC security function.
ATTENTION
•If the vehicle's battery is disconnected at times such as during
servicing, ACC security will be canceled.
•When ignition switch is turned OFF and back to ACC, the
operation of all buttons is disabled. If this happens, resume
normal operation. (Refer to "How to resume normal operation
(ESN security lock out)" on page 31.)
How to turn the security indicator on/off
Once ESN security is activated, the indicator flashes whenever the
vehicle's ignition switch is turned off, warning potential thieves that
the unit is protected. However, if do not want this visible deterrent, it
may be turned off.
With the power OFF, press button [2], then [FUNC]
button and hold both for more than one second.
1
[IND. FLASH] or [IND.-----] appears on the display.
2
[IND. FLASH] means the security indicator will flash when the
vehicle's ignition switch is off, and [IND.-----] means it will not.
Repeat the above steps to reactivate the flash mode.