Filter
Top Products
85
How to operate the tuner
Button [1]
Changing the reception sensitivity for automatic scanning
Turn OFF the power.
1
Press and hold the [FM AM] button, then button [1], and
hold both for more than three seconds.
2
The mode switches between AUTO mode and DX mode each
time the buttons are pressed.
The deck lets you select the reception sensitivity to be used for
automatic scanning of stations. The two sensitivity modes available
for this deck are AUTO mode and DX mode.
AUTO Mode
During automatic scanning, the reception sensitivity
switches automatically to one of two levels. Initially the
reception sensitivity is set to the low level so that only
stations with strong signals are received. If no stations
could be received, the reception sensitivity is increased
so that stations with weaker signals can also be
received.
DX Mode
Because the reception sensitivity for automatic scanning
is set to the high level from the start, even stations with
weaker signals can be received. (Signal crossover may
result in some stations being hard to hear.)
[FM AM] button