Filter
Top Products
24
ESN security operating procedure
First, cancel the existing Key CD.
Refer to "How to cancel the key CD".
Next, program a new Key CD.
Refer to "How to program the Key CD".
2
1
How to change the Key CD
If power is disconnected while ESN security is active (a Key
CD was programmed), operation is disabled until power is
restored and the unit unlocked. Follow this procedure to
resume normal operation.
When the power is turned on after disconnecting the
battery power, a [SEC] message will appear for two
seconds. Thereafter, message changed to [DISC] and
the press the [OPEN] button, then the CD5444 is ready
to accept your Key CD into the slot.
Insert your Key CD.
If the correct CD is inserted, an [OK] message will appear
for two seconds and the CD will begin playing.
2
1
How to resume normal operation (ESN security lock out)
ATTENTION
•If the correct CD is inserted, an [ERR_] ("ERR" and error
number) message will appear for two seconds, after which the
CD will be ejected.
•If [ERR5] (the 5th time an error has occurred) appears, [HELP]
will appear, after which the CD will be ejected. When [HELP]
appears, carry out the operations for an ESN security lock out
by following the procedure in "What happens if an incorrect CD
is inserted?" on page 25.
•You must be use the same CD used for Key CD programming;
a duplicate CD may not work properly.
[FUNC] button
Button [6] [OPEN] button