Filter
Top Products
2. ALARM OUTPUT: This will transmit a signal to another device. The setting of alarms are
NONE = not activated, 1 = output signal 1 transmitted. To change this, simply use the Jog Dial
on the DVR.
3. ALARM DURATION: Permanent, this setting cannot be changed.
4. NETWORK ALARM:
YES: To enable network alarm.
NO: To disable network alarm.
5. SEND EMAIL:
YES: Send an email when HDD’s temperature is overheated.
NO: Will not send an email when HDD’s temperature is overheated.
The email address can be set in the NETWORK SETUP MENU.
6. STOP RECORD:
YES: Stop recording when HDD’s temperature is overheated.
NO: Will not stop recording even when HDD’s temperature is overheated.
7. SET TEMPERATURE:
It is possible to set temperature. When HDD’s temperature is higher than the degree you set, then
all other settings in HDD TEMP. will take effect (BUZZER, ALARM OUTPUT, ALARM
DURATION, NETWORK ALARM, SEND EMAIL, STOP RECORD).