Filter
Top Products
Front Panel Features
See figure 2 to identify the front panel features on the transmitter and receiver.
MTP RL 15HD A Receiver
MTP SERIES
MTP RL 15HD A SEQ Receiver
RGB
PEAKING
LEVEL
RGB
DELAY
PEAKING
LEVEL
MTP SERIES
RED
GREEN
ADJUST
BLUE
SELECT
ON
1 2 3 4 5
H SYNC +
V SYNC +
S-VIDEO
END UNIT
SPARE
ON
1 2 3 4 5
H SYNC +
V SYNC +
S-VIDEO
END UNIT
SPARE
MTP T 15HD A Transmitter
MTP SERIES
50 Hz
RECORD
60 Hz SPARE
EDID
SELECT
ON
6
7
1
61098 7
1
1
4
5
3
2
11
11
Figure 2. MTP 15HD Front Panels
a
Power LED — The LED indicator lights when the unit is receiving power.
b Record LED — The LED indicator flashes red during the EDID recording process to
indicate a new EDID being written to memory. The LED returns to a solid green after the
write completes.
c Record button — The recessed record button is used to initiate recording of the EDID
of a display device (connected to the loop-out) to user-programmable memory position
0 on the rotary switch (
e
).
d Vertical frequency DIP switch — The first DIP switch selects the vertical frequency
for the pre-programmed EDID. When switched to OFF (default position), the EDID
selected by the rotary positions 1 through E are based on 60 Hz. When switched to ON,
they are based on 50 Hz. The second DIP switch, marked SPARE, is not used.
NOTE: When the EDID select rotary switch (
e
) is in position 0 or F, the setting of
the first DIP switch is not applicable because the user-recorded or attached display
EDID is being used.
MTP 15HD A Series • Installation and Operation 6