Filter
Top Products
EDID Conguration
The MTP 15HD A transmitter can either record EDID from a display device, or a
pre-programmed EDID can be selected using the rotary and DIP switches.
Recording a Display EDID
1. Turn the rotary switch to position 0.
NOTE: The vertical frequency DIP switch has no effect in this mode.
2. Connect the display device to the local monitor output connector.
NOTE: The MTP 15HD transmitter should be supplying the necessary 5 VDC to
power on the display. However, to ensure that EDID is being transmitted, power on
the display.
3. When ready to record to memory, press and release the recessed record button
(see
c
on page 6) to begin the recording process. The Record LED (see
b
on
page 6) will flash red rapidly during recording, then return to solid green after recording
is completed. At this time, the display can be disconnected. Connect the source device
to the input connector.
4. Power on or restart the source device if necessary.
Using a Pre-Programmed or User-Recorded EDID
1. If you have not already done so, connect the source device to the MTP 15HD
transmitter. Do not power on the source device at this time.
2. Set the front panel DIP switch (see
d
on page 6) to the required frequency
(50 or 60 Hz).
3. Set the rotary dial (see
e
on page 7) to the required position (see table below).
Positions 1 through E are factory installed. Position 0 is for user-recorded EDID
information. Position F passes the EDID from the display connected to the loop-out
directly back to the input.
Rotary Switch
Position
Resolution
0 User-recorded EDID
1 800x600
2 1024x768 (default)
3 1280x720
4 1280x768
5 1280x800
6 1280x1024
7 1360x768
8 1366x768
9 1400x1050
A 1400x900
B 1600x1200
C 1680x1050
D 1920x1080
E 1920x1200
F Local monitor pass-through
MTP 15HD A Series • Installation and Operation 16