Filter
Top Products
Receiver Rear Panel Features
Figure 6 shows an MTP RL 15HD A receiver, which has all of the connectors and other
features that are on either receiver in the MTP 15HD A series.
MTP RL 15HD A Receiver
NOTE: A “C7” label is affixed to
transmitters designed for
STP201 or CAT 7 cable.
INPUT
BUFFERED
OUTPUT
OUTPUTS
RGB
POWER
12V
.5A MAX
MTP RL 15HD A
L
MONO AUDIO
R
1 2 3
4
5
Figure 6. Receiver Rear Panel
a
Power connector — Plug the included external 12 VDC power supply into this
2-pole captive screw connector (see Power Supply Wiring on page 12 to wire the
connector).
b
Input connector — Connect one end of the twisted pair cable from the transmitter or
from the buffered output connector of an RL receiver to this RJ-45 female connector.
c
Buffered output connector — Connect one end of a twisted pair cable to this female
RJ-45 connector. Connect the free end of the same twisted pair cable from the receiver
to the Input RJ-45 female connector on another receiver (see Twisted Pair Cable
Termination on page 14 to wire the RJ-45 connectors).
d
Output video connector — Connect a projector or other high resolution video device
to this 15-pin HD connector.
e
Mono audio output connector — Insert a 3.5 mm, 5-pole captive screw audio
connector into this connector for two mono audio outputs. Wire the connector as
shown in figure 7. Use the supplied tie-wrap to strap the audio cable to the extended
tail of the connector.
Do not tin the wires!
ATTENTION: Potential damage to property.
For unbalanced audio, connect the sleeve(s) to the ground
contact.
DO NOT connect the sleeve(s) to the negative (-) contacts.
Balanced Audio Output
Tip
Ring
Tip
Ring
Sleeves
Unbalanced Audio Output
Tip
No Ground Here
No Ground Here
Tip
Sleeves
LR
LR
Figure 7. Captive Screw Audio Connector Wiring
NOTE: The length of the exposed wires in the stripping process is critical. The ideal
length is 3/16 inches (5 mm). If the exposed section is longer, the exposed wires
may touch, causing a short circuit between them. If it is shorter, the wires can be
easily pulled out, even if tightly fastened by the captive screws.
MTP 15HD A Series • Installation and Operation 11