Filter
Top Products
4
Design Information
Dual Burner Outdoor Cooktop
• These cooktops are designed for outdoor use
only. Do not locate the cooktop in a building,
garage or other enclosed area.
•Ensure that fresh air ventilation is adequate.
•Consider exposure to wind and proximity to
traffic paths.
•The minimum clearances to combustibles
must be maintained at all times.
Choosing
the Location
•Phillips head screwdriver
•Two adjustable pipe wrenchs
•7/16" socket with extension
•Level
•Pliers
•Flat blade screwdriver (3/32" blade)
Tools &
Materials
Required
(Not supplied)
•Do not install an outdoor cooktop below
overhead unprotected combustible
construction.
•The installation must conform to local codes
or in the absence of local codes, with the
national fuel gas code, ANSI Z223.1a, latest
edition.
• Open the box and remove packaging.
• Remove the cover and grate.
• Remove white plastic tie-downs on burners.
• Open the hardware accessory carton and
check contents.
Step
1
Remove the
Packaging
1/4 - 20 x 1/2" Bolts
Count 2
10 - 24 x 3/4" Screws
Count 2
10 - 24 x 3/8" Screws
Count 4
#10 Flat Washers
Count 2
10 - 24 Lock Nuts
Count 6
1/4 - 20 Lock Nuts
Count 2
1/4" Flat Washers
Count 2
Support Brackets
Count 2
LP MODELS
See Product to Determine Parts Used
3/8" Flare Tee and
Two 3/8" x 3/8" Flare Hoses
(On Models So Equipped)
For Natural Gas Installations:
•Appropriate gas line to reach installation
location
•Pipe joint sealant, approved type and
resistant to LP gases
•Manual shut-off valve
# 10 x 1/4" Thick Round Spacers
Count 2
NATURAL GAS MODELS
Regulator and
1/2" NPT Close Nipple
3/8" NPT x 1/2"
Flare Fitting