Filter
Top Products
Installation
Dual Burner Outdoor Cooktop
•All built-in installations should be at least
35-1/2" above the floor.
Clearances to Combustibles:
•Allow at least 6" clearance from the back and
sides to any combustible material.
•Allow at least 1" clearance below the cooking
surface on all sides.
Installation in a combustible enclosure:
•Installation into a combustible enclosure
requires the ZX2JYSS insulated jacket.
•The insulated jacket must be supported from
the bottom by a solid deck or ledge on each
side beneath the jacket.
6
2A
Installation
Into An
Enclosure
(Skip this step
if burner is installed
on a grill cart)
Step
Installation in a non-combustible enclosure:
•In a non-combustible (masonry) enclosure,
the burner drops into the opening. A solid
deck beneath is required for support from
the bottom.
Combustible enclosure with Insulated Jacket
Non-combustible enclosure
To install trim kit ZX2TKYSS:
•Remove the cover and burner grate.
•Place side trim and rear trim pieces over the
burner edges, overlapping the countertop
surface.
•Install screws from the inside of the burner
and through the trim. 3 each on all sides.
NOTE: The trim kit is not designed to support
the weight of the Dual Range Top Burner.
Support from the bottom must be provided.
24-5/8"
11"
2x2
Opening
for Gas
Supply
Line
1-1/8"
1"
15-3/8"
23-5/8"
10-3/8"
13-1/8"
2x2
Opening
for Gas
Supply
Line