Filter
Top Products
4
Step
Test for
Leaks
WARNING
TEST FOR LEAKS
A complete gas tightness check must be
performed at the installation site. DO NOT
USE A FLAME TO CHECK FOR GAS
LEAKS.
•Do not use the burner until all connections
have been leak tested.
•Repeat leak test after each LP tank change or
gas re-connect.
•Check to be sure the main valve on the LP
tank or the shut-off valve is in the “OFF”
position.
•Make a soap solution of one part liquid
detergent and one part water.
The valve panel must be removed to check
the valves and fittings.
•All control valves should be in the “OFF”
position.
•Remove the knobs.
•Remove the 4 screws holding the valve panel
to the burner.
•Pull the panel outwards and unplug the wire
from the back of the rotary igniter.
TO TEST:
•Apply the soap solution around all
connections, valve and tubing.
•Turn the gas supply on.
•Check all connections from the supply line
or LP tank up to and including the manifold
pipe assembly.
•If a leak is detected, turn gas supply off and
tighten fittings. Turn the gas on and check
again.
•To re-install the valve panel, re-connect the
igniter wire and secure the panel with
original screws.
TO MATCH LIGHT:
•Remove the burner grate.
•Strike match and hold adjacent to burner
port.
•Push and turn the control knob to “LITE”.
•Rotate the control knob to desired setting.
•Replace grate.
ALWAYS TURN GAS SUPPLY OFF AT THE
SHUT-OFF VALVE OR LP TANK WHEN
NOT IN USE.
5
Step
Lighting
the Burner
WARNING
Do not attempt to light
the burner if the odor of gas is present.
CAUTION: Keep hands and face as far away
from the burner as possible when lighting.
•Remove burner cover.
•Turn all knobs to “OFF” position.
•Turn gas supply on at the LP tank or shut-off
valve.
NOTE: When lighting the burner for the first
time or after a LP tank change, up to 20
seconds may be required to purge air from
the lines.
•Push and turn control knob counter-clockwise
to “LITE” position, turn the small igniter
knob next to the burner knob clockwise.
NOTE: The spark will produce a snapping
sound. This is normal.
•If the burner does not light within 4 seconds,
turn knobs to “OFF and wait 5 minutes for
the gas to dissipate before trying again.
•If the burner does not light after several
attempts, the burner can be lit with a match.
9
Installation
Dual Burner Outdoor Cooktop