Filter
Top Products
Installation
Dual Burner Outdoor Cooktop
5
2
Installation
On 27" Cart
(Skip this step if
you are installing
in an enclosure)
Step
The cooktop burner is designed to fit onto
the right side of the 27" grill head.
•Open the grill lid and remove the right
cooking grate and Gourmet Radiant Tray (or
Lava Rock Tray).
Secure Support Brackets to Grill
•Remove the cooktop burner cover, burner
grate and stainless steel aeration pan and
drip tray.
•Remove the two open top burners by
grasping the burner and pulling up and
towards the rear.
•Secure the support brackets to the cart using
two 1/4 - 20 x 1/2" bolts, 1/4" flat washers
and lock nuts as shown. Use a 7/16" socket
with extension to reach the front lock nut.
Secure Cooktop to Grill Head
•Install two 10 - 24 x 3/4" screws and #10
washers from inside the grill head. On the
outside of the grill head, install 1/4" round
spacers onto the bolt.
•Position the cooktop chassis on top of the
support brackets, aligning side mounting
holes with bolts. Push bolt through the
spacer and into the burner box. Secure with
lock nuts.
•Check to be sure the cooktop is level with
the grill head. Loosen mounting bolts and
adjust if necessary.
Secure Cooktop to Support Brackets
•Install the four 10 - 24 x 3/8" screws through
the inside of the burner box and through
the bracket. Secure with 10-24 lock nuts.
•Reinstall the cooktop burner, aeration pan,
burner grate and drip tray.
Support
Bracket
Gas Hose
1/4-20x1/2" Bolts
Bushing
1/4-20
Lock Nut
1/4-20
Lock Nut
1/4" Flat
Washers
10-24 Lock Nuts
10-24x3/8" Screws
Washer
1/4" Spacer
10-24
Lock Nut
10-24x3/4 Screws