Filter
Top Products
Degaussing Coil & Grounding Strap Attachment Specification.
For The Model 1793, 1993, 2093 Video Monitor.
Yoke Connector.
Plugs in main board left side of
flyback transformer.
Degaussing coil Connector
Plugs in main board left side of fuse.
Ground
Connector.
Attach to
CRT socket
board.
1.
The first item to attach to the picture tube is the grounding strap. Lay the tube face
down on a soft surface. Slide the folded over end of the braided wire over the top left
CRT mounting ear (The braided wire is oriented to the left). Attach the spring at the
other end to the left hole of the right bottom mounting ear.
2. Next attach the degaussing coil. Locate the connector wires at the bottom center of
the CRT. Form the degaussing coil to the contour of the tube at the top two corners.
Attach and tighten two 3" wire ties on the inside hole of the top two corners.
Loosely attach two 15" wire ties around the degaussing coil and around the bottom
ears. Tighten the wire ties.
Top of CRT
Anode Connection
Grounding Strap
CPS1791
Spring
15" Wire Tie
CPM2013
2PL
3" Wire Tie
CPM2003
2PL
Degaussing
coil
CPS1771
CPS1828
CPS1847
CPS1860
CAUTION: The ground cable from the enclosure to the monitor chassis
must be connected before applying power to the monitor.
Blue
Black
Schematic:
1
3
2
Bottom
View
(pins)
1
2
3 Blue
104