Filter
Top Products
INITIAL SET-UP
IMPORTANT!
SET-UP FOR NORTH AMERICAN USE
North America’s AM stations are exactly 10 kilohertz apart. At
the factory, the radio is set up for the 9 kilohertz spacing of
stations in Europe. To change this to the 190KHZ spacing:
1. With the radio OFF, press and release the AM button
once.
2. Immediately press and release the STEP button. “10
KHz” now appears in the right side of the display and will
disappear in a few seconds.
This change will be permanently in the radio’s memory as long as
batteries are not taken out for a period of ten minutes or more.
When traveling outside of the Americas, use the same procedure
as above to set the spacing back to 9 kilohertz.
ADDITIONAL SET-UP INFORMATION
1. On the right side of the radio, set the SSB switch to the
OFF position. This feature is described on page 23.
NOTE: the FINE TUNING control, on the right side of
the radio, is only activated and needed when the
YB400PE is in the SSB mode. You do not need to use
this control when listening to regular AM, FM, and
shortwave broadcasts.
On the left side of the radio, set the DX/LOCAL switch to the
DX position. DX allows for maximum sensitivity, the preferred
position.
4