Filter
Top Products
• Remember to press the appropriate Input Selector
0
button
before functions are changed to another device.
3. When all the steps have been entered, press the
MNKL
9
button to enter the commands. The red light under the
Input Selector
0
will blink and then turn off and the Program
Indicator
e
will flash green twice, to confirm the macro to be
programmed.
Example: To program the Macro 1
K
button so that it turns on the
CS3/CS5 and your TV, follow these steps:
• Press the Macro 1
K
and Mute
A
buttons at the same time and
then release them.
• Note that the Program Indicator
e
will flash amber.
• Press the TV Selector
0
.
• Press the Mute
A
button to store the CS’s power on command.
• Press the Screen Power On
Y
button to store the TV Power On
Command.
• Press the
MNKL
Channel Up
9
button to complete the
process and store the macro sequence.
After following these steps, each time you press the Macro 1
K
button, the remote will send all Power On commands.
Erasing Macro Commands
To remove the commands that have been programmed into one of
the Macro buttons, follow these steps:
1. Press the Mute Button
A
and the Macro Button
K
that
contains the commands you wish to erase.
2. Note that the Program Indicator
e
will flash amber, and the red
LED under the Input Selector
0
last used will turn on.
3. Within ten seconds, press the Mute Button
A
.
4. The red LED under the Selector will go out, and the Program
Indicator
e
will turn green and flash three times before it
goes out.
5. When the Program Indicator
e
goes out, the Macro has been
erased.
30
LEARNING CODES FROM A REMOTE CONTROL