Filter
Top Products
UV8035
5
DIN Rear Mount (Method B)
This unit has threaded holes in the chassis side
panels which may be used with the original
factory mounting brackets of some vehicles to
mount the radio to the dashboard. Please
consult with your local mobile stereo shop for
assistance on this type of installation.
1. Remove the existing factory radio from the
dashboard or center console mounting.
Save all hardware and brackets as they will
be used to mount the new radio.
2. Carefully unsnap the plastic trim ring from
the front of the new radio chassis. Remove
and discard the trim ring.
3. Remove the factory mounting brackets and
hardware from the existing radio and attach
them to the new radio. Select a position
where the screw holes of the bracket and
the screw holes of the main unit are aligned
(are fitted). Tighten the screws at 2 places
on each side. Do not exceed M5 x 9 MM
maximum screw size. Longer screws may
damage components inside the chassis.
4. Wire the new radio to the vehicle as out-
lined in the Universal Installation instruc-
tions.
5. Mount the new radio assembly to the dash-
board or center console using the reverse
procedure of step 1.
NOTE: The mounting box, outer trim ring,
and half-sleeve are not used for method B
installation.
Reconnect Battery
When wiring is complete, reconnect the battery
negative terminal.
Screws
Dashboard
Factory
Mounting
Bracket
Hook (Remove)