Filter
Top Products
6
ENGLISH
6
ENGLISH
Storing stations in memory
You can use one of the following two methods to
store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-
station Sequential Memory)
• Manual preset of both FM and AM stations
FM station automatic preset: SSM
You can preset 6 local FM stations in each FM band
(FM1 – 3).
1
Select the FM band number (FM1 – 3)
you want to store FM stations into.
2
Press and hold the both buttons for
more than 2 seconds.
“SSM” appears, then disappears when automatic
preset is over.
Local FM stations with the strongest signals are
searched and stored automatically in the band
number you have selected (FM1 – 3). These
stations are preset in the number buttons — No. 1
(lowest frequency) to No. 6 (highest frequency).
When automatic preset is over, the station stored
in number button 1 will be automatically tuned in.
Manual preset
You can preset up to 6 stations in each band (FM1
– 3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band
1
Select the FM1 band.
2
Tune into a station of 88.3 MHz.
See page 5 fo tune into a
station
3
Press and hold the button for more
than 2 seconds.
Preset number “P1” starts
flashing for a while.
4
Repeat the above procedure to store
other station into other preset
numbers.
Notes:
• A previously preset station is erased when a new station
is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.
EN04-07KS-FX611[U]-9 11/1/01, 3:16 PM6